Simulation of the flow pattern in the bend of 90° degree with the lateral intake in three patial positions 30, 45 and 60 degrees

Authors

  • Maziyar kavousi

Abstract

Flow pattern in a channel bend central angle of 90 ° (wide arc radius ratio (3 = (R / B))), rigid bed with lateral intake at the locations (30,45,60) degrees of arc, using Fluent software. Has been studied In this study,turbulentflow, three-dimensional and constant is assumed RSM turbulence model and the equations used to model the Reynolds stresses. The results show that location is the most suitable location for the intake side is 60 degrees. In this location, the width of the separation zone inside the lateral intake and sediment enters the intake is reduced.

Published

2021-04-30

Issue

Section

Articles